Sears 149.213340 warranty Safety Rules for Drill Presses, Table of Contents

SAFETY RULES FOR DRILL PRESSES

1 DO NOT USE until unit is completely assembled and installed according to instructions

2 USE ONLY CHUCK KEY PROVIDED WiTH YOUR RADIAL DRILL PRESS It is equipped with a self-ejecting pin that elimi- nates hazard of leaving key in chuck

3 ALWAYS WEAR EYE PROTECTION

4 DO NOT WEAR Gloves, necktie or loose fitting ciothing

5 BE SURE DRILL BIT or cutting tool is securely locked in chuck

6 USE RECOMMENDED SPEED for drill accessory and workpiece material

7 ADJUST TABLE OR DEPTH STOP to prevent drilling into table work surface

8 NEVER USE YOUR HANDS TO HOLD workpiece during drilling Clamp it to work surface or use a vise to secure workpiece and prevent rotation

9 NEVER OPERATE drill press if any part is damaged or broken until it is properly repaired or replaced

10 NEVER pLACE YOUR FINGERS in a position where drill or cut- ting tool could contact them if part should shift unexpectedly

11 NEVER PERFORM LAYOUT, assembly or setup work on drill press with cutting tool rotating

12 SHUT OFF POWER, remove drill or cutting too!, and clean table before leaving machine

TABLE OF CONTENTS

WARRANTY			.................................................................		2
GENERAL		SAFETY RULES		FOR POWER TOOLS	2, 3
SAFETY	RULES FOR DRILL			PRESSES	4
TOOLS	REQUIRED				5
UNPACKING			AND CHECKING CONTENTS		5
TABLE OF LOOSE PARTS					5
ASSEMBLY			............................................................................................		6, 7
INSTALLING			RADIAL DRILL	PRESS	7
CONTROLS			AND ADJUSTMENTS		8-11
On/Off			Switch		8
Table		Adjustment			8
Depth		Stop Adjustment			8
Spindle			Return Spring Adjustment		8, 9
Spindle			Speeds		9
Changing Speeds				'	9
Belt Tension Adjustment				.............................................	9, 10
Tilting		Drill Head			10

Rotating	Drill Head		..........................................		10
Moving	Drill Head		In or Out		10
Adjusting		Spindle	Perpendicular	to Table	11
Alignment		of Motor	Pulley to Spindle Pulley		11
OPERATION		......................................................			12
Correct	Drilling Speeds				12
Drilling	Wood				12
Drilling	Metal				12
MAINTENANCE		........................................................			12
ACCESSORIES		......................................................			13
REPAIR PARTS					14, 15
TROUBLESHOOTING			.................................................		16
HOW TO ORDER REPLACEMENT				PARTS	16