OPERATION
TO EMPTY THE SOLUTIONTANK
METHOD 1
See Figure 11
When (:leaning is completed, both the Recovery Tank and the
Solution Tank should be emptied prior to storage. Empty the Recovery Tank as described earlier. There are three methods of emptying the Solution Tank.
Method 1 :
1.Disconnect Pump Cord from Recovery Tank,
2.Remove Recovery Tank from Solution Tank and pour solution out of the Filler Opening.
Method 2:
1.Place Floor No_le in bath tub or container.
2.Depress Solution Release Trigger and spray until empty,
Method 3: | METHOD 2 | METHOD 3 | |
1. | Remove Floor Nozzle and insed Wand | into Solution Tank |
|
| through the Filler Opening. |
| Fi_. 11 |
2. | Vacuum solution out, |
| |
|
| ||
:3. All solution is now in Recovery Tank. Empty Recovery Tank as described eadier.
ADDITIONAL USES
DRY VACUUMING
See Figure 12
Your Cleaner COmes with a disposable paper dust bag to trap and collect dirt when used for dry pick up. it is very important that the disposable paper dust bag remain clean to allow air to pass through it while trapping did. If the dust bag is over filled or its pores become dogged from fins powders, no air can pass through. This greatly reduces the efficiency of your cleaner and could Pause the dust bag to burst. To maintain your cleaner'speak efficiency, check the disposable paper dust bag often and replace when clogged or approximately one half full.
TO INSTALL DUST BAG
1. TURN POWER SWITCH OFF AND DISCONNECT
POWER CORD FROM ELECTRICAL OUTLET. 2, Lift Latches and remove Power Head from Unit.
3.Grasp Cardboard Collar of Dust Bag and push Collar as far as possible onto Bag Adapter Tube. NOTE: For greater ease in assembly, slide bottom of Cardboard Collar onto Adapter Tuba first, then pull top of Collar over
Adapter Tube.
4.Position Dust Bag around sides of tank to allow motor
assembly to fit back into unit.
5, Bend top flap of Cardboard Collar inward,
6.Replace Power Head on unit, aligning the word "VACUUM" with Hose Inlet on Recovery Tank _s shown in F_g. 10. NOTE: Be careful not to crush Dust Bag or to
deform flexible splash plate on Power Head when assembling,
7, Unplug Short Power Cord from Recovery Tank Power Head. (See FTgure 2, page 4)
CARDBOARD
COLLAR
DUST
BAG
BAG ADAPTER
TUBE
_g. 12
c;IUTIoN: PAPER DUST BAG IS FOR DRY PICK UP ONLY. DO NOT USE WHEN VACUUMING UP WATER OR
OTHER LIQUIDS!
