TROUBLE | SHOOTING CHART | |
PROBLEM | POSSIBLE SOLUTIONS* | |
1. Neither vacuum motor nor pump | 1. | Be sure power switch is in "ON" position_ |
motor runs. | 2. | Be sure power cord is plugged in securely. |
| 3. | Check wall electrical outlet (by plugging in a known |
|
| working electrical appliance). |
2.Vacuum motor runs, but there is no spray at the nozzle.
1.Be sure Electrical Cord from Power Head to Solution
Tank is securely plugged into receptacle on the Power Head.
2.Check that Solution Tank is full.
3.Be sure Pump Switch is in the "HI" or "LO" position.
4.Nozzle Ports may be clogged. See illustration below to unclog.
3.Spray from the floor nozzle comes out of one side of the nozzle only.
4.Motor runs but cleaner does not pick up ,=',lutionfrom carpet (no exhaust from top of cleaner).
i | . , | .j,i | J, |
1. Unclog the Nozzle Pod. See illustration below.
1.Recovery Tank isfull of dirty water and must be emptied. 2/Check for clogged hose or nozzle. Clogs could result from picking up material such as carpet strings, shoe laces,
etc.
5. Spray connections leak. | 1. Disassemble nut at leaking connection. Be sure washer |
| is properly seated. Reassemble and tighten securely. |
"If the "Possible Solutions" to "Problem,s"listedin the chart do not correctthe problem, take your cleaner to a Sears Sen/ice Center for professional service, Repairs not listed in this chart require professional and specific knowledge of this model cleaner and could result In safety hazards and pemonal injury'if not made by a qualified Sea_ Service Technician.
TO UNCLOG NOZZLE PORT
See FTgure 16
1. Insert the point of a needle or pin into
Spray Port to unclog. |
|
NOTE: Do not let the point of needle or pin | SPRAY PORT |
touch any part of the Spray Pad surface or |
|
Spray Pad will not spray solution properly. |
|
.,,, | ,, L .... | i |
CAUTION: Do not let needle or pin touch this surface.
NEEDLE OR
PIN
Fig. 16
