A TEMPORARY adapter may be used to connect the charger to a
WARNING: Improper adapter con- nection can result in electrical shock.
Before using an adapter as illustrated, be certain that the center screw of the outlet plate is grounded. The green colored grounding clip of the adapter must be attached by a metal screw to a properly grounded outlet. If unsure whether outlet is properly grounded, contact a professional electrician. If necessary, replace the original outlet cover screw with a longer one that will secure the grounding clip to the outlet cover and make a ground connection to the grounded outlet.
Using an extension cord
The use of an extension cord is not recommended. If you must use an extension cord, please make sure that you follow these guidelines:
•Make sure the pins on the plug of the extension cord are the same number, size, and shape as those of the plug on the charger.
•Use only
•Check that the extension cord is properly wired and in good electrical condition.
•Use the recommended minimum AWG (American Wire Gauge) to be sure that wire size is large enough for the rating of the charger.
MINIMUM RECOMMENDED EXTENSION CORD
Length of Cord, in Feet | 25 | 50 | 100 | 150 |
AWG* Size of Cord | 18 | 14 | 12 | 10 |
*AWG=American Wire Gauge
Preparing your battery to be charged
It is important that you read and follow these guide- lines while you are preparing to charge your battery.
•Make sure that you have a 12 volt
•If you have a battery with removable cell caps, if required, add distilled water to each cell until the battery acid reaches the level indicated by the manufacturer. This will help purge excessive gases from the cells. Be careful not to overfill. If you have a sealed battery without cell caps, no action is neces- sary. Continue to the next step listed below.
•Take time to read all battery manufacturer’s specific precautions, such as removing or not removing cell caps while charging, and recommended rates of charge.
•Wear safety glasses. See additional "Personal Safety Precautions" on page 2.
•Be sure that the area around the battery is well ventilated while it is being charged. If ventilation is poor, any gases emitted from the battery can be manually blown away by using a piece of cardboard or other
•If it is necessary to remove the battery from the vehicle to charge it, always remove the grounded terminal from the battery first. A spark may be caused if all accessories in the vehicle are not completely turned off.
NOTE: A marine battery installed in a boat must be removed and charged on shore.
6
