Using Your Battery Charger
To obtain the best results from your battery charger, you must know how to use it properly. This section tells how to set the controls and how to charge a battery in and out of the vehicle.
Setting the controls
All the controls for your charger are located on the front of the unit. Follow these instructions to obtain the accurate charge level for your battery.
OUTPUT SELECTOR SWITCHES
Two switches are used to select the rate of charge or
• | 2 Amp Trickle Charge — Use for charging small |
| batteries and warming large batteries. The lower the |
| charge rate, the longer it will take, but the battery is |
| subjected to much less stress. |
• | OFF — Leave the switch in the OFF Position while |
| connecting the charger to the battery and to the AC |
| power outlet. |
• | Select — This setting enables you to select one of |
| the two |
200A 12V
ENGINE
START
➞
40A 12V CHARGE
2A 12V
CHARGE
OFF
SELECT
position switch. | |
• | Use the 40 Amp Charge rate for a fast charge. |
• | Use the 200 Amp Engine Start for cranking the |
| engine. Remember that little or no charging has |
| been done by the charger and, unless your trip is |
| quite long, your battery will still need further |
| charging by the vehicle's charging system once |
| the engine starts. |
AMMETER
The AMMETER indicates the measured amount of amperes being drawn by the battery. When you first start charging a battery, the reading will be high, with the needle near 40 at the 40 AMP CHARGE rate. As the battery charges, the needle will fall to about 15 to 20 amps, indicating a charged battery.
At the 2 AMP CHARGE rate, you will notice very little needle movement.
When cranking the engine while using the ENGINE START feature, the needle will swing into the Start (red) area of the scale.
VOLT/AMP SELECTOR
7