Briggs & Stratton 5900664, 5900692 manual Uncrating, Battery Installation, Connect Battery

		S200X 25HP & 27HP - 61” Mower Deck
	Uncrating
1.	Using a reciprocating utility saw or equivalent, cut	A
	crate away from bottom skid. Remove crate. Remove
	shrink-wrap plastic.
2.	Cut nylon banding from front of the frame and rear
	rear bumper.
	IMPORTANT NOTE
	When cutting crate from bottom skid,
	use caution around tractor tires and
	mower rollers.	Figure 1. Hydraulic System By-Pass
3.	Open the hydraulic release valves. To open the	A. Hydraulic Release Valve
		(left-hand pump shown)
	release valves, turn the release valve, which is
	located on front of the pump, counter-clockwise 2 full
	turns MAX. See Figure 1 for valve location.	A
4.	Push down on the parking brake lever (A, Figure 2)
	to release the parking brake.
5.	Be sure there are no nails or sharp objects on the
	bottom skid to puncture the tractor’s tires. Roll the
	tractor forward off the bottom skid.
6.	After moving the tractor, re-engage the pumps (drive
	position) by turning the release valves clockwise and
	tighten to 80-120 in/lbs (9-13.5 N.m.).

Battery Installation

WARNING

BATTERY SAFETY RULES

•Battery acid causes severe burns. Avoid contact with skin.

•Wear eye protection while handling the battery.

•To avoid an explosion, keep flames and sparks away from the battery, especially while charging.

•When installing the battery cables, CONNECT THE POSITIVE (+) CABLE FIRST and the negative (-) cable last. If not done in this order, the positive terminal can be shorted to the frame by a tool.

Connect Battery

1.Connect the red positive battery cable (B, Figure 3) to the positive battery post.

2.Connect the black negative battery cable (A) to the negative battery post.

Figure 2. Disengaging the Parking Brake (lever shown in disengaged position)

A. Parking Brake Lever

A

B

Figure 3. Connect the Battery

A.Positive (+) Cable & Terminal

B.Negative (-) Cable & Terminal

7/2007 3 TP 300-7333-02-M2-SP