S200X 25HP & 27HP - 61” Mower Deck
Roll Bar Installation
Install the Roll Bar
1.Unpack the roll bar and hardware from the box.
2.Place the roll bar in to the roll bar pockets (A, Figure 6) on the frame. Refer to Figure 7 for the correct roll bar orientation.
3.Install the allen head bolt with a flat washer through the bottom hole of the roll bar pocket and roll bar from the rear of the machine. Secure with a flat washer and the center lock nut. Repeat for the other side.
4.Install the hex head bolt with washer through the top hole of the roll bar pocket and roll bar from the rear of the machine. Secure with a flat washer and the center lock nut. Repeat for the other side.
5.Tighten installation hardware to 80 ft/lbs (108 Nm) of torque.
A
Figure 6. Roll Bar Pocket (Left Side Shown) A. Roll Bar Pocket
Figure 7. Roll Bar Orientation
7/2007 | 5 | TP |