Manuals / Briggs & Stratton / Lawn and Garden / Lawn Mower

Briggs & Stratton 5900664 Adding Fuel, Starting The Engine, S200X 25HP & 27HP - 61” Mower Deck

Models: 5900664 5900692

1 19

Download 19 pages 24.9 Kb

Page 13

Adding Fuel

	S200X 25HP & 27HP - 61” Mower Deck
	Adding Fuel	A
		A
To add fuel:
1.	Remove the fuel cap (see A, Figure 29).
2.	Fill the tank to about 1-1/2” (3,81 cm) of the bottom of
	the filler neck. This will allow for fuel expansion.
NOTE: Do not overfill. Refer to your engine manual for
specific fuel recommendations.
3.	Install and hand tighten the fuel cap.	Adding Fuel
	Figure 29.	Adding Fuel
	A. Fuel Cap

Starting The Engine

1.While sitting in the operator’s seat, engage the parking brake and make sure the PTO switch is disengaged and the motion control handles are locked in the NEUTRAL position.

2.Set the engine throttle control to FULL throttle position. Then fully close the choke by pulling the knob OUT fully.

3.Insert the key into the ignition switch and turn it to

START.

4.After the engine starts, gradually open the choke (push knob down fully). Reduce to half throttle speed and allow to warm up.

Warm up the engine by running it for at least a minute before engaging the PTO switch or driving the rider.

5.After warming the engine, ALWAYS operate the unit at FULL THROTTLE when mowing.

7/2007

13

TP 300-7333-02-M2-SP

Image 13

Briggs & Stratton 5900664, 5900692 manual Adding Fuel, Starting The Engine, S200X 25HP & 27HP - 61” Mower Deck

Contents

TABLE OF CONTENTS ATTENTION SETUP PERSONNELDealer Setup Adjustment Instructions S200X - 25HP, 27HP & 32HP 61” & 72” Mower DeckQuick Setup List S200X 25HP & 27HP - 61” Mower DeckConnect Battery Battery InstallationUncrating S200X 25HP & 27HP - 61” Mower DeckMotion Control Handle Assembly Tractor AssemblySeat Assembly S200X 25HP & 27HP - 61” Mower DeckInstall the Roll Bar Roll Bar InstallationS200X 25HP & 27HP - 61” Mower Deck A Figure 6. Roll Bar Pocket Left Side Shown A. Roll Bar PocketCheck Tire Pressures Check Fluid LevelsCheck the Engine Oil Level Check the Hydraulic Oil LevelInstall Deck Pusher Bars 72” Models AssemblyCheck the Mower Check Torque - Mower BladesS200X 25HP & 27HP - 61” Mower Deck Install the Mower Deck 72” ModelsFigure 17. Adjust Lift Rod Timing Check Deck Rod TimingS200X 25HP & 27HP - 61” Mower Deck Figure 16. Check Lift Rod TimingNOTE Before adjusting the deck level, the deck lift rod Adjustmenttiming must be checked and/or adjusted Place the deck height adjustment pin in theS200X 25HP & 27HP - 61” Mower Deck Check Deck Drive BeltS200X 25HP & 27HP - 61” Mower Deck LubricationNOTE Front casters should be lubricated annually Starting The Engine Adding FuelS200X 25HP & 27HP - 61” Mower Deck NOTE Do not overfill. Refer to your engine manual forSAFETY INTERLOCK SYSTEM Perform the Safety ChecksFunctional Tests Operational SAFETY ChecksSeat Adjustment Suspension Seat Seat AdjustmentAdjustment ProceduresTO ADJUST THE HANDLE ALIGNMENT Motion Control Handle AdjustmentTO ADJUST THE HANDLE PLACEMENT TO ADJUST THE HANDLE HEIGHTReturn-To-Neutral Neutral AdjustmentIt is important to note that after every adjustment of the adjustment linkage rod, the lever must be pulled rearwardS200X 25HP & 27HP - 61” Mower Deck Parking Brake Adjustment5,0 - 5,4cm 5375 N. Main St Munnsville, NY Contact Information Briggs & Stratton Yard Power Products Group