8.11Powering a 120V AC Device To operate a 120V AC device:

1.Ensure that the battery clips are securely on the storage holders.

2.Open the protective cover of the AC power outlet on the front panel of the jump starter.

3.Make sure the 120V AC device to be operated is turned OFF.

4.Plug the 120V AC device into the AC power outlet, and turn the Inverter/Compressor Switch to the INVERTER position.

5.Turn the device on.

6.If the device does not operate properly when first connected to the inverter, push the inverter rocker switch ON, OFF, and ON again in quick succession. If this procedure is not successful, it is likely that the inverter does not have the required capacity to operate the device intended.

7.Charge the jump starter as soon as possible after each use.

Risk of electric shock.

Incorrect operation of your inverter may result in damage and personal injury. The inverter output is 120V AC and can shock or electrocute the same as any ordinary household AC wall outlet.

120V AC Electrical Device Example Run-Time Chart

Appliance Type

Estimated Power

Estimated Time*

Spotlights, Sump Pumps, DVD Players

100 Watts

1.5 Hours

Faxes, TVs, Small Power Tools

150 Watts

1.25 Hours

Computer Printer, Medium Power

200 Watts

55 Minutes

Tools, Blenders

 

 

NOTE: These are estimated run-times, actual time may vary. Times are based on the internal battery being new, fully charged and operated at room temperature.

NOTE: The maximum continuous load is 400 watts. Do not use the inverter with a product that draws more than 400 watts, as this may cause damage to the inverter and the product.

9.MAINTENANCE INSTRUCTIONS

9.1After use and before performing maintenance, unplug and disconnect the jump starter

(see sections 3 and 4).

9.2Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips, cords and the jump starter case.

9.3Ensure that all of the jump starter components are in place and in good working condition, for example, the plastic boots on the battery clips.

9.4Servicing does not require opening the unit, as there are no user-serviceable parts.

9.5All other servicing should be performed by qualified service personal.

10.Moving and STORAGE INSTRUCTIONS

10.1Store the jump starter in an upright position.

10.2Store inside, in a cool, dry place.

10.3Do not store the clips on the handle, clipped together, on or around metal, or clipped to cables. The clips on the jump starter are live and will produce arcing or sparking if they come in contact with each other. To prevent accidental arcing, always keep the clips on the storage holders when not using them to jump start a vehicle.

10.4If the jump starter is moved around the shop or transported to another location, take care to avoid/prevent damage to the cords, clips and jump starter. Failure to do so could result in personal injury or property damage.

Do not use and/or store the jump starter in or on any area or surface where damage could occur if the internal battery should unexpectedly leak acid.

9

Page 10
Image 10
Sears 28.71988 Powering a 120V AC Device To operate a 120V AC device, Risk of electric shock, Maintenance Instructions