Sears 28.71988 Estimated Time for Inflating, Using the Inflator Risk of explosion

NOTE: To prevent overheating, the compressor has built-in thermal protection that will turn the compressor off before it overheats. If the compressor shuts off, wait a few minutes and it will automatically restart when the compressor cools.

NOTE: The air compressor is rated for 150 PSI.

Estimated Time for Inflating

Vehicle Tires 13" to 16"	6 to 24 minutes
Bike Tire	1 to 3 minutes
Sports Balls	30 seconds

These times are approximate; use the air compressor gauge to ensure the proper pressure has been reached. Do not overinflate.

8.7Using the Inflator

Risk of explosion.

Read instructions of the product being inflated before using the inflator. Avoid overinflation, do not exceed the manufacturer’s recommended pressures. Do not leave the inflator unattended during use.

1.Ensure that the battery clips are securely on the storage holders.

2.Attach the corrugated hose with end adapter to the high-flow inflator port located near the inflator ON/OFF switch on the back of the jump starter.

3.The main accessory adapter attached to the corrugated hose accommodates up to 4 sizes. If another size is needed, an additional adapter can be attached to the end of the main accessory adapter.

4.Insert the adapter into the product to be inflated.

5.Push the Inflator switch to the ON position and inflate the product.

6.When product is inflated to the desired level, push the Inflator switch to the OFF position and remove the adapter.

Estimated Time for Inflating

24" Beach Ball	1 to 3 minutes
Pool Raft	4 to 6 minutes
Queen-size Air Mattress	4 to 8 minutes
2 Person Boat	8 to 10 minutes

Times are estimates and will vary depending on size and product features.

8.8Using the Deflator

1.Ensure that the battery clips are securely on the storage holders.

2.Attach the corrugated hose with the end adapter to the high-flow deflator port, which is located on the side of the jump starter.

3.The main accessory adapter attached to the corrugated hose accommodates up to 4 sizes. If another size is needed, an additional adapter can be attached to the end of the main accessory adapter.

4.Insert the adapter into the item to be deflated.

5.Push the Inflator switch to the ON position and deflate the item.

6.When the product is deflated to the desired level, push the Inflator switch to the OFF position and remove the adapter.

8.9Before Using the Inverter Important Safety Instructions:

1.Keep the jump starter well ventilated in order to properly disperse heat generated while it is in use. Make sure there are several inches of clearance around the top and sides, and do not block the vents on the back of the jump starter.

2.Make sure the jump starter is not close to any potential source of flammable fumes, gases or clothing.

• 7 •