MAINTENANUI=
WHEN SERVICING USE ONLY IDENTICAL REPL'/_CEMENT PARTS
POWER CORD OR SWITCH REPLACEMENT | HANDLE |
1. UNPLUG YOUR SAW. | COVER |
2.Remove screws and wing nut securing handle cover. See Figure 17.
3.Carefully lift handle cover away from tool.
4.Note the locations of all lead wiring inside the handle and how each connection has been made. IMPORTANT: When the new cord or switch is in- stalled, identical connections must be made.
5.Remove the lead wires from the switch by insert- ing a 1/32" diameter pin or nail into each switch lead receptacle and pull the lead wires as shown in Figure 16. This will release the wires. Remove the pin or nail with a twisting motion.
6.To replace lead wires, push each lead wire into its proper receptacle. NOTE: Be sure to push lead wires into switch as far as possible.
7.Locate the switch in the handle and place all wir- ing so it cannot be pinched or contact screws when handle cover is replaced.
8.Replace handle cover, screws, and wing nut.
9.Tighten screws and wing nut securely.
GENERAL
Only the parts shown on parts list, page 15, are in- tended to be repaired or replaced by the customer. All other parts represent an important part of the double insulation system and should be serviced on- ly by a qualified s_rvice technician.
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to various types of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, carbon dust, etc.
SCREWS | 1/32" DIAMETER |
| |
| NAIL OR PIN |
WING NUT /
SCREW
Fig. 17
When electric tools are used on fiberglass boat sports cars, etc., it has been found that they are sut ject to accelerated wear and possible prematut failure, as the fiberglass chips and grindings a_ highly abrasive to bearings, brushes, commutato etc. Consequently it is not recommended that th tool be used for extended work on any fibergla_ material. During any use on fiberglass it is extremel important that the tool is cleaned frequently by blov ing with an air jet. ALWAYS WEAR SAFET GLASSES, DUST MASK, OR EYESHIELDS BEFOR BEGINNING POWER TOOL OPERATION OR BLOV ING DUST.
THE FOLLOWING RECOMMENDED ACCESSORIES WERE AVAILABLE AT THE TIME THIS MANUA
WAS PRINTED.
Cord | Lock _ | 2595) | 71/4 Saw | Blade | _ | 32303) | ||
71/4 Saw | Blade | _ | 32423) | |||||
Carrying | Case (914702) | |||||||
71/4 Saw | Blade | _ | 32494) | |||||
Rip | Guide | (9_27679) | ||||||
71/4 Saw | Blade | _ | 32564) | |||||
50' 14 A.W.G. | Ext. Cord (9 5821) | |||||||
100' 14 A.W.G. | Ext. Cord (9 83508) | |||||||
|
|
|
| |||||
71/4 Saw Blade _ 32664) 71/4 Saw Blade _ 32444) 71/4Saw Blade _ 32526) 71/4Saw Blade (932518) 7l/;_ Saw Blade _ 32489)
_Theuse of attachments or accessories not listed above might be hazardous.
Page 12
