LIFT-UP COOKTOP
The cooktop can be raised or removed so the area underneath (burner box bottom) can be cleaned.
To raise ¢ooktop:
1.Remove the burner grates, bowls and knobs.
2.Grasp the cooktop at the front and lift up.
3.Raise the support rod Into place to hold the cooktop while cleaning. Securethe rodlnto the spacer bracket on the cooktop.
Porcelain enamel can chip If dropped. Handle porcelain enameled cooktops carefully.
To lower the cooktop:
1.Carefully replace the support rod and lower the cooktop. Press into place. Make sure the strikes fit in the catches to fasten the cooktop.
2.Replace the burner grates, bowls and knobs.
REMOVABLE COOKTOP
BURNERS
The cooktop burners on your range may be removed for cleaning. Be sure all cooktop knobs are turned to OFF and burners are cool, then rentove or raise the cooktop.
If shipping screws were not removed from the burner when the range was Installed, do so now (see your Installation section for Instructions).
To remove burners:
1.Grasp the burner head and tilt It to the right to release the two tabs from the burner support (A In Fig. A).
2.Lift the end of the burner assembly, then pull away from the front of the range to free the air shutter from the gas valve orifice (Fig. B). Check all lighter and
burner ports. If they are clogged, use a wire or needle to clear them.
See the Cleaning Chart.
Be careful not to disturb the air shutter setting
while cleaning. If you need to readjust the air shutter, see the Installation Section.
To replace burners:
1.Sliptheair shutterover the gas valve orifice (Fig. A).
2.Lower the burner assembly and hook the tab in the slots In the burner support (Fig. A).
3.Be sure both tabs are in their slots, that the burner sits level and straight and that the flash tube forms a straight line from the igniter to the burner (Fig. B).
GAS VALVE
ORIFICE
AIR SHUTTER
MGHTER PORTS
IGNITE_
_
_ FLASH TUBE
BURNER PORTS
11 |
