Sears 385. 564180 owner manual Rl o

Needle clamp screw [he Iett

®

(_ Disconnect the machine from the power supply.

Raise the needle to its highest position. Then loosen the needle clamp screw for the needle you are going to remove,

Refer to page 24 for changing the needle

for three-thread serging.

Needle clamp	I I	Needle slopper
screws
-..	/ r]l o	,o
		Ed0oo,
_		needle	bar
	"_\ Needle
Fiat stale		Needte.	I

to lhe back

f

1" Correct needle setting)

2_ J

To Attach the needle on the right

Insert new needle into the needle clamp with the flat side to the back until the top of needle touches the stopper pro, then tighten the needle clamp screw on the right.

To attach the needle on the left

Insert new needle into the needle clamp with the fiat side to the back until the top of needle touches the edge of needle bar, then tighten the needle clamp screw on the left.

* When the needles are set correctly, the left	NOTE: Your	overlock	uses	standard	Kenmore
needle is higher than the right one,	sewing	needles	(HA-1	SP, #!1,	#14).

No speciai needles are required,

Do not use any needle which Is bent or blunt.

28