Sears 385. 564180 owner manual Needle thread Ension dial Lever thread Thread take-up guide

_=

needle thread

I [ension dial

_-_

lever thread

Thread take-up [_ guide

2® J

Needle guide

Needle bar thread 0

\

-Gently pull all four thread ends towards back of machine.

-Replace presser foot (See page 27}.

-Return knife to up position (See page 29).

--Close side and looper covers.

--Turn hand wheel toward you to chain off three or four stitches.

--Place fabric under the toe of the presser foot; it is not necessary to raise the foot,

(_ Insert the thread between tension discs from the right. Then pull both sides of thread.

(_ Turn the hand wheel toward you to bring needle bar to its highest position, then pass the

thread through thread take-up lever thread

gu ide.

®Pass the thread through the thread guide sliding the thread from right to left.

®Pass through needle bar thread guide from left to right.

_) Thread the left needle from the front to the back and pull the thread about 10 cm (4") from the eye ot the needle to the back under the foot,

NOTE: Needle may be easier to thread if you remove presser toot (See page 27) and lower knife (See page 29}.

17