16.Relievespring t_ )sion on lift lever (see figure 18 and note below) loosening hex jam nut and un- screwing adiustr_lent bolt
justment bolt. iiii1_ NOTE
Tractor lift lever must be positioned all the way back and locked in position.
BACK VIEW (TRACTOI_)
ADJUSTMENT BOLT JAM /
r "ATTACHMENT O
• LIFT SPRING
FIGURE 18
17.Move attachment lift lever all the way forward and lock in position. See figure 28 on page 10.
18.Assemble lift arm link over channel rod and insert
pivot shaft end (from R.H. side of tractor) into hole in L.H. lift pivot plate. See figure 19. Secure lift arm link to channel rod with 1/8" (large) hairpin cotter. See figure 19
19.Assemble the frame bracket (RH) under the right
hand foot rest of the tractor usin_
strip threads. See figure 19.
20.Assemble trunnions that were assembled're the lift link rods in step 12, through
RIGHT HAND SIDE VIEW | FRONT |
| 7116" FLAT |
LIFT LINK ROD | WASHI |
| @ |
HAIRPIN |
|
COTTER |
|
(SMALL) | LIFT ASSEMBLY |
LIFT ROD TRUNNION, | ARMS |
PLAIN NUT AND LOCK NUT
FIGURE 20
21.Assemble lift pivot plate over right hand end of lift assembly pivot shaft and connect to outside of frame bracket using two 3/8" x 314" clevis pins from inside. Secure with two 3/32" (small) hairpin
cotters. Secure ends of pivot shaft to each lift pivot plate with 1/8" (large) hairpin cotter. See figures 20 and 21.
RIGHT HAND SIDE VIEW | FRONT |
| |
CLEVIS PINS |
|
FRAME |
|
BRACKET |
|
R,GHTHANDSIDEVIEWFRONT
3/8 X 3/4" | FRAME | BRACKET | J// |
|
REX | / |
|
| |
BOLTS_ | / | J | / | /_ |
S.AFTENO
,IFT ASSEMBLY__
LIFT PIVOT MOUNT PLATE | ROD |
(L.H.)
FIGURE 19
|
| LIFT |
| LIFT PIVOT | ASSEMBLY |
| PIVOT SHAFT | |
CLEVIS PINS | PLATE |
|
|
|
FIGURE 21
22.Assemble support bracket onto right hand side of tractor using two 3/8 °x 1" hex bolts inside and secure, with, 3/8" lock washers, and 3/8" hex lock nuts on outside. See figure 22.
8