Sears 486.24412 owner manual Bracket

HAIRPIN

COTTER

\

- LIFT LEVER	SUPPORT	i	T
.-,-BRACKET
			HANDLE
3/8" X 1 "---_---_ ]			GUIDE
HEX BOLTS '=_---,	-,

,_3/8"_HEX'I2OCK NUTS -_.

UP STOP BRACKET

FIGURE 22

27.Wrap plastic tie around handle tube and cable, (see figure 24), assembling end of tie through lock. Pull plastic tie tight to retain cable to handle tube near front of tractor hood. Cut oft extra plastic end.

28.Assemble grip assembly to handle assembly us- ing one 5/16" x 1-1/2" hex bolt and one 5/16" hex lock nut. NOTE: Do not over tighten lock nut, grip assembly must pivot freely.

5/16" x 1-1/2"	CABLE END f3_"HEX
	FFn'ING
HEX BOLT	LOCK NUT

23.Assemble handle guide (with loop outside) at top of support bracket and secure with one hairpin cotter inside. See figures 22 and 23.

HANDLE	HANDLE HAIRPIN	HANDLEI
GRIP	COTTER	GUIDE

/

GRIP

ASSEMBLY

HANDLE

ASSEMBLY

114"WELD BOLT

FIGURE 25

HANDLE GUIDE

CABLE

(OUTSIDE GUIDE'

LSUPF_ORT

-BRACKET

ICONTROL3/4". CABLE END

FIGURE 23

24. Assemble handleassemblydownthrough handle guide as shown in figure 23. Secure lower end of handle to top side of blade pive_ bracket with special shoulder bolt (on top) and 3/8" hex whizl0ck nut underneath. See figure 24.

25.Assemble one 5/16-24" hex nut onto threaded end of control cable approximately 3/4" from end.

Assemble threaded end of cable up through cable mount ear and secure with second 5/16-24" hex

nut. See figure 24.

26.Assemble handle grip on upper end of handle

assembly if not already pre-assembled. See

29.Assemble ball end of cable (see figure 23), through round hole in cable end fitting and into slot of fitting. See figure 25. Assemble cable end fitting over 1/4" weld bolt on grip assembly and secure with one 1/4" hex lock nut. NOTE: Do not over tighten lock nut, cable fitting must pivot freely.

(R.H.) HITCH PLATE FRONT

L.H.) HITCH PLATE

SHAFT END

figure 23.

CABLEPLASTIC

/ //

#

/

GUIDE

BRACKET

ASSEMBLYCHANNEL

ASSEMBLY

FIGURE 26

SPECIAL

SHOULDER

BOLT

3/8" HEX

WHIZLOCK NUT

BLADE

HANDI_I_ PIVOT

TUBE BRACKET

30.Assemble guide bracket assembly shaft end into the left hand hitch plate. See figure 26. Slide

guide assembly back to the right and into the hole in the right hand hitch plate, and secure with a hairpin cotter on each end. See figure 27. Lower front end of guide bracket assembly to straddle channel assembly. See figure 27.

FIGURE 24 9