Sears 486.24412 owner manual TRACTOR,TractorPreparation, Assembly Of Snow Bladeto Lawn

4.Assemble angle stop to top of channel using one

1/4" x 5/8" hex bolt down through left hand hole, and one 1/4" hex lock nut under channel. See

figure 5. Do not tighten at this time,

I_"HEX LOCK NUT	CHANNEWPIVOT
	PLATE	_BLY

1/4" X 5/8"

HEX BOLT

ANGLE STOP

FIGURE-5

5.Assemble 3/8" x 1-1/4" carriage bolt through square hole in cable mount bracket and through square hole in lock bars. See figures 6 and 7. Hold cable

mount bracket in position as shown in figure 7 and secure with 3/8= lock washer and 318" hex lock

nut.

	,1
318" X 1-114"	318" HEX NUT
CARRIAGE BOLT	LOCK WASHER
\
CABLE MOUNT
BRACKET

FIGURE 6

6.Assemble one 5/16-24" hexjam nut onto threaded end of control cable approximately 3/4" from end. Assemble threaded cable end through round hole in cable mount bracket and secure with another 5/16-24" hex jam nut. See figure 7.

CABLE

MOUNT

t BRACKET

,.°-..EX [

7.Assemble ball end of cable through round hole in cable end fitting and into slot of fitting. See figures 7 and 8.

1/4" X 1-1/4"

HEX BOLT

CABLE END

LONG SPACER	FITTING
ANGLE STOP

PUSH

1_" HEX LOCK NUT

FIGURE 8

8.Assemble 1/4" x 1-1/4" hex bolt down through cable end fitting, through long spacer, angle stop, (right hand hole)and through channel. See figure

8.Secure with 1/4" hex lock nut and tighten the other 1/4" hex lock nut, which was left loose in

step 4. NOTE: Keep cable and fitting in align- ment with cable mount bracket when tighten-

ing nuts.

ASSEMBLY OF SNOW BLADETO LAWN

TRACTOR,(TractorPreparation)

A.Remove mower or any other attachment you may have mounted to your tractor. Mark all loose parts

and save for re-assembly. Refer to tractor owners manual for removal of mower/attachment.

B. Remove and save suspension arm with nut and

washer from both lift link rods and up stop bracket with nuts and bolts from tractor frame to allow

assembly of snow blade. Also remove the 318" self-tapping bolts from each side of the tractor

frame as shown in figure 9. The lift link nuts will be used later to install snow blade brackets.

REMOVE 3/8"	FRONT ---*"
SELF-TAP BOLTS	TRACTOR FRAME
	R.H. SIDE

ARM

LIFT LINK NUT AND WASHER

NUTS _

(REMOVE AND SAVE

UP STOP

FIGURE 7

BRACKET

FIGURE 9

5