Sears 486.24412 owner manual Assembly Instructions

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

1)7/1 6" Open End or Box Wrench _1) 1/2" Open End or Box Wrench

(1)9/16" Open End or Box Wrench

3/8"	X 1-1/4"	_-,,---'---'3/8"	HEX NUT	I
CARRIAGE BOLT
			3_"LOCK
(TOP	HOLE
			WASHER

(1)3/4" Open End or Box Wrench

(1)Adjustable Wrench

(1)Hammer

Refer to carton contents figure on page 2 and figure 1 on page 3 for parts and hardware needed to assemble dozer blade.

RIGHT HAND (R.H.) AND LEFT HAND

(L.H.) ARE DETERMINED FROM

OPERATOR'S POSITION WHILE

ANGLE

SLOT

SPRING PIN

HOLE

CHANNEUPIVOT

FRONT

ANGLE LOCK

SEATED ON TRACTOR.

PLATE ASSEMBLY

FIGURE 3

SPRING

1.Assemble curved end of angle lock spring into small hole in washer as shown in figure 2.

T

I

IANGLE LOCK SPRING .

3.Assemble the offset end of angle lock spring into small holes in angle lock bars as shown in figure

3.Slide lock bars through lock bar slot until spring pin hole is aligned with bracket on back side. See figure 4. Using a hammer drive 1/4 =x 1=spring pin into lock bars until flush with bracket. See figure

4.Tighten nut in angle lock bars which was left loose in step 2.

LO

. POSITION \ \ \

F G--ffffiT

2.Assemble the two angle lock bars together as shown in figure 3, using one 3/8" x 1-1/4" carriage bolt down through the top holes with a 3/8" lock

washer and a 3/8" hex nut underneath. Do not tighten at this time.

114-x 1"		\
SPRING PIN	_	'_

FIGURE 4

rs_	NOTE
Lock ba	pivot freely and when

pulled all the way back the channel/pivot plate assembly should be unlocked and free to pivot to right or left position notches.

4