![](/images/new-backgrounds/1101850/10185037x1.webp)
..........................SERVICE ADJUSTIVIE TS
TO REPLACE BELTS
The drive belts on this snow thrower are of special con- struction and should be replaced with original equipment belts available from your nearest SEARS Store or Serv- ice Center°
You will need the assistance of a second person while replacing the belts,,
Drain the gasoline from the fuel tank by removing the fu el line. Drain the gas and reinstall fuel line,,
BELT COVER
/
cAo,,o.: ouTI
DOORS, AWAY FROM FIRE OR FLAME I
,,, ,,, | ,, | , | Ill, | • |
AUGER DRIVE BELT
if your snow thrower will not discharge snow, and the auger drive belt is damaged, replace it as follows:
•Disconnect the spark plug wire°
eRemove the belt cover (See Fig. 26)
®Loosen the belt guides (See Fig, 28) and pull away from the drive pulley°
oLoosen the auger idler pulley (See Fig. 28) and slip the belt out,
eEngage the auger drive lever,, This will pull the brake assembly (See Fig, 27) away from the pulley and allow the belt to be slipped out.
eRemove the belt from the auger drive engine pulley°
eInstall the original equipment replacement belt in reverse order of removal,
•Release the auger drive lever,,
®Place the drive belt onto the auger drive pulley.
•Adjust the drive belt (see To _djust Auger Drive Belt paragraph on page t8),,
oAdjust the belt guides (see To Adjust The Belt Guides paragraph on page 20).,
®Reinstall the belt cover_
®Check clutch control cable adjustment (see page 18),,
eReconnect the spark plug wire,
| 1/4 X I12 INCH SELF | ||
| TAPPING SCREW | ||
FIG, 26 |
|
| |
TRACTION | DRIVE BELT |
| |
| TRACK DRIVE | ||
IMPELLER | PULLEY |
| |
DRIVE | GUIDE | ||
BELT_ | (Left Hand) | ||
| AUGER DRIVE | ||
BELT GUIDE | PULLEY | ||
(Right |
|
| |
AUGERIDLER | TRACK | DRIVE | |
IDLER | PULLEY | ||
|
PULLEY
19