Sears 536.884811 To Remove Snow Thrower, HOW to SET UP Your Snow Thrower, To SET the Skid Height

ASS

Figure i showsthe snowthrowerin the shipping position,,

Figure 2 shows the snow thrower completely assembled,,

Reference to the right and left hand side of the snow thrower is from the operator's position at the handler

TO REMOVE SNOW THROWER

FROM CARTON (See Fig 1)

eCut all four corners of the carton from top to bottom and lay the panels flat..

®Cut the cable ties attached to the auger,,

eCut and discard the plastic ties that secure the crank assembly and place the assembly aside,,

®Remove the packing material from the control panelo

eCut and discard the packing securing the clutch cables to the handles.

oLoosen (do not remove) both botts securing the upper and lower handles., Swing the upper handle into the operating position.

NOTE: Ifthe cables have become disconnected fromthe clutch levers, reinstall the cables as shown in Figure 3.

®Tighten both bolts securely..

eRoll the snow thrower off the skid by pulling on the handle.,

NOTE: This snow thrower is equipped with a track drive and can be hard to push when the engine is not running It is easier to pull the snow thrower backward if it must be moved without the engine running

The drive system may be tight when you first use your snow thrower tt loosens up as you use it

HOW TO SET UP YOUR SNOW

THROWER

TO SET THE SKID HEIGHT

®To adjust the skids height for different conditions,

see To Adjust Skids Height paragraph on page 17,,

i,

CAUTION: IF YOU ARE REMOVING

SNOW FROM ANY ROCKY OR UNEVEN

SURFACES, RAISE THE FRONT OF THE SNOW THROWER BY MOVING THE SKIDS DOWN, THIS WILL HELP TO PREVENT

ROCKS AND OTHER DEBRIS FROM BEING PICKED UP AND THROWN BY THE AUGER.

LY

CONTROL

LOWER HANDLEPANEL

CRANK

ASSEMBLY

CLUTCH

CABLE

HANDLE

ASSEMBLY

FIG. 1

FIG. 2

	DRIVE
"Z" FITTING	LEVER

._"I'HI'H I I I ,III

FIG. 3

7