Figure1showsthesnowthrower in the shipping position
Figure 2shows the snow thrower completely assembled
Reference to the right and left hand side of the snow thrower is from the operator's position at the handle.
TO REMOVE SNOW THROWER
FROM CARTON (See Fig. 1)
•Remove staples from the top of the carton
•Locate and remove container of 5W30 oil.
•Locatethe crank assembly and place the assembly aside
oRemove and discard the packing material from around snow thrower
oCut all four corners of the carton from top to bottom and lay the panels flat
=Remove the packing material fromthe control panel and upper handle assembly
•Rollthe snowthrower off the carton by pulling onthe lower handle+
CAUTION: Do Not back over cables
®To complete upper handle instaltation and install chute crank assembly, see To Install The Upper Handle and Crank Assembty paragraph on page 8
CABLE
UPPER
HANDLE
ASSEMBLY
ii iin,,
FIG. 1
NOTE: If the cables have become disconnected from lhe clutch levers, reinstall the cabfes as shown in Fig, 3.
HOW TO SET UP YOUR SNOW |
|
THROWER | FIG. 2 |
Your snow thrower is equipped with height adjust |
|
skids (See Fig 2) on the outside ot the auger hous- |
|
ing. To adjust the skid height for different conditions, |
|
see To Adjust Skk:l Height paragraph on page 17+. |
|
"Z" FITTING
" | CAUTION: | IF' YO'U'"'ARE | 'R'E'r_0VING |
SNOW FROM ANY GRAVELED OR UJ_-
EVEN SURFACE, RAISETHE FRONTOF
THE SNOW TH ROWER BY MOVING THE
SKIDS DOWN+ THIS WILL HELP TO PREVENT
STONES AND OTHER DEBRIS FROM BEING
PICKED UP AND THROWN BY THE AUGER.
TRACTION
DRIVE
LEVER
7