Kenwood VR-5900 Setting Up on the Receiver, Seting, Preparation for setup, Speaker setup

It is possible to set up the speakers on the receiver main unit.

However, some of the setting items such as the controlled device registration should also be set on the PowerTouch. If setup is made on the PowerTouch, it is not necessary to repeat any setup on the receiver side.

Up	Therefore, it is recommended to perform setup on the
	PowerTouch. This chapter describes the setup on the receiver
	only as an alternative method in case the setup is not made

Setting Up on the Receiver

Button layout

A SPEAKERS B	I NPUT	CD 2/TAPE 2 LISTEN		THX	SOUND	fi	MULTI	%	fi P.CALL %	MEMORY AUTO	BAND
	MODE	MONITOR	MODE				CONTROL
	RF	RF BAND	DISPLAY		SET UP
	ON/OFF

Seting	on the PowerTouch.
	Do not operate the PowerTouch during the receiver setup.
	Preparation for setup
	Most of the receiver control buttons are accommodated
	inside the panel door. Make the following preparation for
	setup on the receiver.
46	1.	Plug the power cord into a household power outlet.
	2.	Press the POWER switch to supply the main power. The
		receiver now enters the STANDBY mode (in which re-
		mote control is available). Then press the ON/STANDBY
		button to turn the receiver ON.
	3.	Open the panel door.

Press the DOOR OPEN/ CLOSE button to open the panel door. To close it, press the button again.

Panel door

Speaker setup

1.Selecting the speakers Selecting the SUBWOOFER:

1 Press the SET UP button (SOUND button) inside the panel door until “SUBWOOFER OFF (or ON)” message appears on the display ( for more than 2 seconds ).

2Press the MULTI CONTROL (fi/%) button to select ON (when a subwoofer is used) or OFF (when not).

Selecting the FRONT speakers:

3Press the SET UP button to display “FRONT NML/ THX (or FRONT LARGE)”.

4Press the MULTI CONTROL (fi/%) button to select FRONT LARGE (large-sized speakers) or NML/THX (normal-sized speakers).

If the SUBWOOFER is set to OFF, the FRONT speak- ers are set automatically to LARGE and the CENTER speaker selection display appears automatically.

Selecting the CENTER speaker:

5Press the SET UP button to display “CENTER NML/ THX (or LARGE or OFF)”.

6Press the MULTI CONTROL (fi/%) button to select CENTER LARGE (large-sized speaker), NML/THX (normal-sized speaker) or OFF (no center speaker).

If the FRONT is set to NML/THX, the CENTER speaker can be set to only either NML/THX or OFF.

Selecting the SURROUND speakers:

7Press the SET UP button to display “SURR NML/ THX (or LARGE or OFF)”.

8Press the MULTI CONTROL (fi/%) button to select SURR LARGE (large-sized speakers), NML/THX (normal-sized speakers) or OFF (no surround speaker).

When the FRONT is set to NML/THX, the SUR- ROUND speakers can be set to only either NML/THX or OFF.

When SURROUND OFF is selected, SURROUND BACK is set automatically to OFF and the SW Re- Mix setting menu is displayed.

If the SUBWOOFER is set to OFF, selecting SW RE- MIX step will be skipped.

Selecting the SURROUND BACK speakers:

9Press the SET UP button to display “S.BACK NML/ THX (or LARGE or OFF)”.

0Press the MULTI CONTROL (fi/%) button to select S. BACK LARGE (large-sized speakers), NML/THX (normal-sized or THX speakers) or OFF (no surround speaker).

When the FRONT is set to NML/THX, the SURROUND BACK speakers can be set to only either NML/THX or OFF.