Chapter Four : Warnings and Specifications
Chapter Four: Warnings and Specifications
Read this page carefully to ensure safe operation.
Warnings | 2201 East Dominguez St., Long Beach, CA | |
FCC WARNING | Telephone: | Audio Section |
|
|
Specifications
This equipment may generate or use radio frequency en- ergy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.
NOTE: This equipment has been tested and found to com- ply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro- vide reasonable protection against harmful interference in a residential installation. This equipment may cause harm- ful interference to radio communications if it is not installed and used in accordance with the instructions. However, there
56 is no guarantee that interference will not occur in a particu- lar installation. If this equipment does cause harmful inter- ference to radio or television reception, which can be de- termined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and the receiver.
•Connect the equipment into an outlet on a circuit dif- ferent from the one that the receiver is connected to.
•Consult the dealer or an experienced radio/TV techni- cian for help.
FCC Compliance Notice
These devices comply with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received, in- cluding interference that may cause undesired operation.
KENWOOD U.S.A. CORPORATION
IC(Industry Canada) Notice
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Note to CATV System Installer:
This reminder is provided to call the CATV system installer’s attention to Article
NOTE: Do not use contact cleaning agents because they could cause a malfunction. Be especially careful not to use contact cleaning agents containing oil, since they may de- form the plastic components.
Rated Output Power during stereo operation
130 watts per channel minimum RMS, both channels driven, at 6 Ω from 20 Hz to 20 kHz with no more than 0.03% total harmonic distortion (FTC).
Effective Output Power during surround operation
(Simultaneous power) |
|
|
Front |
|
|
20 Hz to 20 kHz, 0.06 % T.H.D. at 6 Ω | ........ 130 W + 130 W | |
Center |
|
|
20 Hz to 20 kHz, 0.06 % T.H.D. at 6 Ω | ........................ 130 W | |
Surround |
|
|
20 Hz to 20 kHz, 0.06 % T.H.D. at 6 Ω | ........ 130 W + 130 W | |
Total Harmonic Distortion | 0.005 % (1 kHz, 10 W, 6 Ω ) | |
Frequency Response (IHF’66) |
|
|
CD1 | 7 Hz ~ 90 kHz, 0 dB, | |
DVD 6CH | 7 Hz ~ 100 kHz, 0 dB, | |
Signal to Noise Ratio (IHF ‘66) |
|
|
PHONO (MM) | 74 dB | |
CD1 | 97 dB | |
Input Sensitivity / Impedance | 2.5 mV / 47 kΩ | |
PHONO (MM) |
| |
CD1 | 200 mV / 47 kΩ | |
DVD 6CH | 200 mV / 47 kΩ | |
Output Level / Impedance | 200 mV / 2.2 k Ω | |
TAPE REC |
| |
PRE OUT (Front, Center, Surround, Subwoofer) .. 1 V / 1 kΩ | ||
Tone Control |
|
|
Bass | + 7 dB (at 100 Hz) | |
Treble | + 7 dB (at 10 kHz) | |
Loudness Control |
|
|
Volume at | +6 dB (100 Hz), +3 dB (10 kHz) | |
Digital Audio Section
Sampling Frequency | ............. 32 kHz, 44.1 kHz, 48 kHz, 96 kHz |
Input Level / Impedance / Wavelength | |
Optical | |
Coaxial | 0.5 |
Output Level / Impedance / Wavelength
Optical | |
Coaxial | 0.5 |
