Ifusinganotherchemicaldesignedforusewith pressurewashers,preparethechemicalsolutionas requiredbythechemicalmanufacturerFill. chemicalreservoir(s)withthepreparedsolutionas needed.
RotatetheDial-A-CleanerTM selector knobto the
letter correspondingto the desired reservoir.
Open the chemical valve handle fully on the dual lance by turning it countemlockwiseto place the cleaning system in low pressure mode. Detergent cannot be applied with the chemical valve handle in the high pressure position.
•Connect garden hose to water inlet, check that
high pressure hose is connected to spray gun and pump (see ASSEMBLY on page 4), and start engine,
Wash and Rinse Surface
This CraftsmanCleaning System permitsregulationof output water pressureby varyingthe engine speed. The Pressure CommandTM found on the front panel may be set, as follows:
Pressure Low toHigh
DutyLight Medium Heav"t
Application Auto Concrete Paint removal
Boat Driveway Degreasing
Furniture Deck
After you have applied detergent, scourthe surface
clean, as follows:
•Close the chemicalvalve handle fullyon the dual lance by turningit clockwiseto place the cleaning system in high pressure mode. Chemical will not flow when in the high pressure mode.
withSelectthehighandpressurewaterinstallthedesiredstreamnozzlefollowingtheand then rinse it instructionson'Howto Use the Nozzles" on page 6.
Adjust PressureCommancFM control to obtain desired water pressure.
Expand the spray patternfor a more gentle dnsing action. Startat top of area to be dnsed, working. down with same actionas for cleaning.
Attachgarden
to hoseto waterinlet
A CAUTION: Before starting yourCleaning
System, make sure you have read and followed the instructionsin the sections =Before Starting the Cleaning System"on page 8 and "To Start the Cleaning System" on page 8.
A WARNING: Be extremely careful if you must use the cleaning system from a ladder, scaffoldingor any other relatively unstable location.When you press the trigger, the recoil from the initial spray could force you to fall, or if you are too close to the cleaningsurface, the high pressure spray could force you off a climbingapparatus.
Start at lower portion of area to be washed and work upward, using long, even overlapping strokes.
Allow detergent to 'soakin'(between
be cleaned. Make sure there is no damage caused by the high pressurespray.
RINSE SYSTE'_MAFTER EVERY USE
It is imperativethat the chemical selectorsystem be rinsed afterCAUTION:each useTesttoapreventsmall areacloggingorof the surfaceleaks:to
Fill the System Rinse reservoirwith clean water. Before disconnectingthe water supply,start your' cleaning system.
A CAUTION: Before startingyour Cleaning System, make sure you have read and followed the instructionsin the sections"Before Starting the Cleaning System"on page 8 and "To Start the Cleaning System"on page 8.
Open the chemicalvalve handle fullyon the dual lance by tuming it counterclockwiseto place the cleaningsystem in low pressure mode.
Rotate the
continuethe flow until no detergent foam is observed.
•Rotate the
OFF position.