SECTION 1
WATER SOFTENER START-UP
1C.PROGRAM THE TIMER
2. SET WATER HARDNESS NUMBER:
■Press the SELECT button once to display 15 (flashing) and HARDNESS.
The grains per gallon (gpg) hardness of your water supply is on your water analysis report. Be sure to enter water test results on page 2, for future reference.
NOTE:
If your water supply contains iron, compensate for it by adding to the water hardness number.
a a a ad ad
a dd ad
a I a
d ad
| 15 gpg hardness |
2 ppm iron x 5 = 10 | +10 |
(times) | 25 HARDNESS NUMBER |
■ Press the UP/DOWN buttons to set your water hardness number in the display. The DOWN button moves the display to 1. The UP button moves the display to the highest setting (see maximum setting for your model in the specifications).
NOTE:
Each press of the UP/DOWN button changes the display by 1 between 1 and 25. Between 25 and the highest number, the display changes 5 at a time… 25, 30, 35, etc. Continuous pressure on the UP or DOWN button changes the display twice each second.
3. SET RECHARGE (REGENERATION) TIME:
■Press the SELECT button once to display 2:00 AM (flashing) and RECHARGE TIME.
At the 2:00 AM RECHARGE TIME setting, the softener begins re< generation (see pages 11 and 12) at 2:00 AM, ending no later than 4:00 AM. This is a good time in most households because water is not being used (see AUTO< MATIC BYPASS, page 13).
If a different RECHARGE TIME setting would be better for your household, do the following.
■ Press the UP/DOWN buttons to set the desired RECHARGE starting hour. Be sure to observe the AM<PM as you did when setting the time of day.
NOTE:
Each press of the UP/DOWN buttons changes the display 1 hour. Continuous pressure on the UP or DOWN button changes the display twice each second.
■Press the SELECT button once again to return the present time (steady) of day and RECHARGE TONIGHT in the display.
IF YOU NEED HELP PROGRAMMING THE TIMER, CALL TOLL FREE, NUMBER
SEE PAGE 10 FOR OTHER FACE PLATE TIMER FEATURES.
7
