SECTION 1
1D. SANITIZING THE
Care is taken at the factory to keep your water
softener clean and sanitary. Materials used to make the softener will not infect or contaminate
your water supply, and will not cause bacteria to form or grow. However, during shipping, stor- age, installing and operating, bacteria could get into the softener. For this reason, sanitizing as follows is suggested (17when installing.
WATER SOFTENER
WATER SOFTENER
ADD WATER
Salt Hole
Cover
hose
START-UP
Brinewell
1.Lift the salt hole cover and use a pail or hose
to fill the salt storage tank with at least 3 gallons of water.
o Remove the brinewell cover (FIG. 3) and
pour about 3/4 ounce of common 5.25%
household bleach (Clorox, Linco, BoPeep, White Sail, Eagle, etc.) in the softener brine- well.
o Press the
3 seconds to start a recharge. This first re- charge does several things.
-It draws the bleach into and through the softener to sanitize it.
-It fills the salt tank to the water level need- ed.
-It gets all the air out of the resin tank.
-It makes the resin bed (see page 11) ready for service.
NOTES:
This recharge takes about 2 hours.
You can sanitize the softener with or with-
out salt in the storage tank.
Water,
About 3 Gallo_.._
Cover "emove and add
about 3/4 oz. bleach)
Brinewell
_'1:; Recommended by the Water Quality Association. On some water supplies, the water softener may need pe- riodic disinfecting.
