Sears 625.34854 HOW Your Water Softener Works 2A.FACE Plate Timer Features, Recharge NOW

SECTION 2

HOW YOUR WATER SOFTENER WORKS

2A.FACE PLATE TIMER FEATURES

EXTRA RECHARGE

Sometimes, a manually started regeneration

(recharge) may be desired, or needed. Two

examples are:

- -You have used more water than usual (guests

visiting) and you may run out of soft water

before the next timer started regeneration.

-- You did not refill the softener with salt before it was gone.

You can start a regeneration right away, or you

can set the timer to regenerate at the next 2:00

AM (or other preset recharge time). Do the following.

RECHARGE NOW

• Press the ON/OFF-

HOLD button and holduntil

mm

RECHARGE NOW, SERV

and FILL begin to flash in

the display. Upon reaching fill, the first cycle of regen-

eration, the flashing SERV

goes off and FILL is on

steady. RECHARGE NOW

continues to flash. This re-

generation will last for

about 2 hours. After the 2

hours, you will have soft

water again.

RECHARGETONIGHT

• Press	and release (do	not
hold)	the ON/OFF-HOLD		$
button.	RECHARGE	TO-	llms
			IImJ
			m4

SALT MONITOR SYSTEM

The face plate timer has a low salt monitor with

an indicator light to remind you to refill the

storage tank with salt. To set this monitor system:

1, Lift the salt hole cover and level the salt in the

storage tank.

e The salt level decal, on the brinewell inside

the tank, has numbers from 0 to 8 (see

drawing on page 9 and below). Observe the

number the leveled salt is at or closest to.

NOTE: To light the salt storage area, press the

TANK LIGHT button on the face plate.

o Now, press the SALT LEVEL ADJUST button

until black bars display up to the salt level

number. For example, the pictures below show the salt level at 6.

e Finally, set the level you want the low salt

indicator light to come on. Press the SIGNAL

LIGHT ADJUST button until a (÷) shows

opposite this number. In the example below,

the light will come one when the stored salt

drops to level 2. At level 2, the storage tank is

about 1/3 full. This is the lowest you should

allow the stored salt level to drop to. To turn

the salt monitor off, press the button until OFF shows.

		indicator
			light
/	s,,,		\0
	MONITOR

brinewetl	SYSTEM
m

SALT

LEVEL

8_

NIGHT		flashes	in the	dis-	Ima_
					m_
play,	and	the	softener	be-
gins	regeneration		at	the

salt7 level

decal

I

m3

m2_

next	preset	recharge	time.
Press and release the ON/
OFF-HOLD		button	once
more	if you	decide	to cancel
the	regeneration,		and RE-
CHARGE		TONIGHT.

6

/

black

boxes

NOTE:

For accurate salt monitor operation, always use

nugget or pellet water softener salt. See page 9.

10