ASSEMBLY
Assembly | requires two people. Set the treadmill | in a cleared | area and remove | all | packing | materials. Do not | |||
dispose of the packing materials until assembly is completed. | Refer to the | _rawings | below to identify the small | ||||||
parts used | in assembly. Assembly | requires the | included allen wrenc h | _ and | your own | phillips | screw- | ||
driver | , adjustable | wrench | _pen | end w_'_rlch |
| and | scissors | :_. | |
Handrail Washer |
|
| Extension | Leg Screw | 1/2" Screw |
|
|
|
|
| |
|
|
|
| I7 |
|
| Flange | Nut | _. | Handrai! B°!tS 5_ |
|
|
|
| D | ||
3/8" Washer | __ |
| 31/2" | Handrail Bolt |
1. With the help of a second | person, carefully lay the | 34 | |
treadmill on its right side as shown (refer to the drawing | |||
| |||
on page 4 to identify the right side). |
| ||
Insert the Extension Legs | (41) into the treadmill. Make | 41 | |
sure that the Extension Legs are turned so the Base Pads (36) are on the indicated side. Attach each Extension Leg with an Extension Leg Screw (34).
With the help of a second person, carefully raise the treadmill to the upright position so the Extension Legs (41) are resting flat on the floor.
Shipping Bolt Bracket
Refer to the inset drawing. Remove the nut, bolt, and | Nut |
shipping bracket from the left Upright (14). |
|
2.Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions in step 2 to lower the treadmill.
16
Position the Left Handrail (2) on the left Upright (14) as shown. Thread a Handrail Bolt (15) with a Handrail Washer (16) into the left Upright and the Left Handrail. Do not tighten the Handrail Bolt yet,
Attach the lower end of the Left Handrail (2) to the
Extension Leg (41) with a 3 1/2" Handrail Bolt (89), a 3/8"
Washer (99), and a Flange Nut (57). Do not tighten the
Handrail Bolt yet,
