3.Withthehelpofasecondperson,holdtheConsoleBase (6)andtheRightHandrail(32)neartherightUpright(14). FeedallexcessWireHarness(26)downintotheright Upright;ifnecessary,bendtheWireHarnessasshown.
RoutetheWireHarness(26)throughthebracketonthe
RightHandrail(32)asshown.Insertthebracketintothe rightUpright(14).
Referto theinsetdrawingPushtheStrainReliefClip(88). ontotheWireHarness(26).Inserta 1/2"Screw(13)into theStrainReliefClipandintotheindicatedholeinthe RightHandrail(32).MakesurethatthereisnoslackWire HarnessbetweentheStrainReliefClipandtheConsole Base(6).TightentheScrewintotheConsoleBase.
IMPORTANT: The Strain Relief Clip (88) must be attached as instructed,
4.Attach the Console Base (6) to the Left and Right Handrails (2, 32) with three 1/2" Screws (13).
13
5.Thread a Handrail Bolt (15) with a Handrail Washer (16) into the right Upright (14) and the Right Handrail (32). Do not tighten the Handrail Bolt yet,
Attach the lower end of the Right Handrail (32) to the Extension Leg (41) with a 3 1/2" Handrail Bolt (89), a 3/8" Washer (99), and a Flange Nut (57).
Tighten all parts used in this step and in step 2
6.Attach the Storage Latch (12) to the left Upright (14) with two 1/2" Screws (13). Be careful not to overtighten the Screws.
Refer to the inset drawing. Remove the backing from the Adhesive Clip (74). Press the Adhesive Clip onto the base of the Uprights (14) in the indicated location. Press the Allen Wrench (73) into the Adhesive Clip.
13
12
74 73
7Make sure that all parts are tightened before you use the treadmill To protect the floor or carpet, place a mat under the treadmill
