ASSEMBLY
Before beginning assembly, carefully read the
following Information end Instructions:
• Assembly requires two people.
•Due to the size ofthe BODYLIFT, itshould be
assembled inthe location where itwill beused.
•Place all parts of the BODYLIFT ina cleared area
and remove the packing materials;do not dis-
pose of the packing materials untilassembly is
completed.
•Read through each assembly step before you
begin.
•For help identifyingthe smallpads used in
assembly, remove the PART IDENTIFICATION
CHART from the center of this user's manual.
Note: Some small parts may have been pre-
attached for shipping purposes. Ifa partis not
found in the partsbag, check tosee if ithas been
pre-attached.
•As you assemble the BODYLIFT, make sure that
all parts are oriented exactly as shown inthe
drawings.
•Tighten all parts as you assemble them, unless
instructedto do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
Two (2) adjustable wrenches
One (1) standard screwddver
One (1) phillips screwdriver
One (1) rubber mallet
Assembly will be more convenient ifyou havethe
followingtools: Asocket set,a set ofopen-end or
closed-end wrenches, or aset ofratchet wrenches.
.
,
Before you begin, read the information and
Instructions at the top of this page. Note: The
BODYLIFT requires a minimum ceiling height
of 7 1/2feet.
Insertthe four 3/8" x 2 1/2" Carriage Bolts (70) up
throughthe indicated holes inthe Base (1).
Slide the Rear Upright (2) onto the four3/8" x
2 1/2" Carriage Bolts(70) in the Base(1). Make
sure that the Rear Upright is turned as shown.
Tighten a 3/8" Nylon Jam Nut (41) onto each
Carriage Bolt.
2
70
70
InsertThese
Carriage
BoltsFirst
4