MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately.
Note: For clarity, the pedal disc is shown removed in the drawing below.
To clean the elliptical, use a damp cloth and a small | Next, locate the Reed Switch (58). Loosen, but do not | |
amount of mild soap. IMPORTANT: To avoid damage | remove, the M4 x 16mm Screw (92). | |
to the console, keep liquids away from the console |
| |
and keep the console out of direct sunlight. |
| |
CONSOLE TROUBLESHOOTING |
| |
If the console display becomes dim, replace all the bat- | 86 | |
teries at the same time; most console problems are the |
| |
result of low batteries. See assembly step 6 on page | 92 | |
9 for replacement instructions. | ||
| ||
| 41 | |
If the console does not display your heart rate when | 58 | |
you use the handgrip heart rate monitor, see step 5 on | ||
page 18. |
| |
HOW TO ADJUST THE REED SWITCH |
| |
If the console does not display correct feedback, the |
| |
reed switch should be adjusted. |
| |
To adjust the reed switch, you must first remove the |
| |
Shield Cover (37). Using a flat screwdriver, release |
| |
the tabs along the sides of the Shield Cover and then |
| |
remove the Shield Cover. |
| |
37 |
|
Next, rotate the Pulley (86) until a Magnet (41) is
aligned with the Reed Switch (58). Slide the Reed
Switch slightly toward or away from the Magnet. Then, retighten the M4 x 16mm Screw (92).
Rotate the Pulley (86) for a moment. Repeat these actions until the console displays correct feedback.
When the reed switch is correctly adjusted, reattach the shield cover.
20
