4. Tip: Avoid pinching the Main Wire (42). Slide
the Upright (2) onto the Frame (1).
4
Have a second person hold the Shield Cover (37) out of the way.
Attach the Upright (2) with five M10 x 20mm Screws (79) and five M10 Split Washers (78).
Tip: Start all the Screws before fully tighten- ing them.
Press the Shield Cover (37) into the Left and Right Shields (44, 45).
Avoid pinching the
Main Wire (42)
37
2 
44, 45 | 79 | 78 | 78 |
79
1
5. Orient the Handlebar (39) as shown. Have a | 5 |
|
|
second person hold the Handlebar near the |
|
| |
|
|
| |
Upright (2). |
|
| 79 |
|
| 39 | |
|
|
| |
Locate the Sensor Wires (93) in the Handlebar |
|
|
|
(39). Insert the right Sensor Wire into the right |
|
| 79 |
side of the Upright and insert the left Sensor |
|
| |
|
|
| |
Wire into the left side of the Upright. Pull the |
|
|
|
Sensor Wires upward out of the top of the |
|
|
|
Upright. | 2 | 93 |
|
|
|
Tip: Avoid pinching the wires. Attach the
Handlebar (39) to the Upright (2) with three M10Avoid pinching the wires
x 20mm Screws (79).
8
