4. Connect the Sensor Wire (15) tothe wire on the Monitor
(1). Insert any excess wireinto the Frame (6). Attach the
Monitor to the Frame witha#8 x1/2" Screw(16), Make
sure not to pinch the wire between the Frameand the
Monitor.
5. Apply asmall amount of grease tothe shaftson the
lower end of the Pedal Frame (7). Slide a Pedal (12)
onto the dght shaft. Makesure thatthe indicated plastic
tube is facing the Pedal Frame. Usingthe includedpedal
tool,tap a 1/2" Push Nut (30) onto the shaft. Make sure
that the Push Nutis turned so the teeth bend away from
the Pedal (see the insetdrawing).
Attach the other Pedal (notshown) in the same manner.
6. Remove the two 114"x 2" Screws (17) attachingthe Seat
(3) to the underside ofthe Seat Tube (5). Attach the
Seat, with the narrow end forward, to the top of the Seat
Tube with the two Screws as shown.
7. Pivot the Pedal Frame (7) until the Magnet (27) is
aligned with the Reed Switch (15) (see the inset
drawing). Loosen the #8 x 3/4" Screw (18)oSlide the
Reed Switch towardthe Magnet until theretoisa 1/8" gap
between the Reed Switch and the Magnet. "13ghtenthe
#8 x3/4" Screw.
"'-- 6
Grease .. -"_-..._ iF')
Plastic <_ 1_2/_307 P_ed
Tube
,+ ,+
___ (Teeth al
--30 Tool
6 Narrow End
5