Sears 831.287628 i

1. Tap a 1/2" Bushing (25) into each side of the Frame (6)

as shown.

Apply grease to the Pivot Rod (21). Align the holes in

the Pedal Frame (7) withthe indicated tube on the

Frame (6). Tap the Pivot Rodthrough the Pedal Frame

and the Frame.

IMPORTANT NOTE: Before assembling the 112"

Dome Caps (29), make sure that you thoroughly

understand the assembly step(s) they are used in.

They can be assembled only once. If they must be

removed, you will need to order newDome Caps.

Center the Pivot Rod(21) and tap a 1/2"Dome Cap

(29) onto each end of it.

Make sure that the Magnet (27) ison thePedal Frame

2. Make sure that there isa 1/2" LinkArm Bushing (19) in

the rightLink Arm (4) (see the insetdrawing). Slide the

LinkArm onto the indicated pinon the Pedal Frame

(7). Pivot the Pedal Frame and tap a1/2"Dome Cap

(29) onto the pin.

Attach the left Link Arm (not shown)in the same

manner.

3. Make sure that there is a I 1/4" x 2" Endcap (13)on

each end of the Handlebar (2). The Endcaps must be

turned so the round ends are on top.

Slidethe Handlebar (2) into the Pedal Frame(7). The

Handlebar must be turned sothe sidesbend toward

theSeat (not shown). Align the holes In the Handlebar

withthe holesIn the Pedal Frame. Attach one side of

the Handlebar with two#8 x 1/2" Screws (16). Attach

the otherside of the Handlebar with two #8 x 112"

Screws.

Slide the I 1/4" x 2"Endsaps (13)down over the Pedal

Frame (7).