ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove the packing matedals. Do not dis-
pose ofthe packing matedals until assembly is completed. Assembly requires the Included allen wrench |,a
phillips screwdriver _====(Z_), two adjustable wrenches _and scissors L__
(not Included).
.Refer to the drawing on page 4 and Identify the right
slde of the treadmill. With the helpof a secondperson,
carefully lay the treadmill onits dght side; do not lay the
treadmill on its left side or the storage latch may be
damaged.
Firmlyslide a Base Extension (76) into one side of the
Base (86). Usingthe AllenWrench (89), tighten an
ExtensionBolt (13) into the Base Extension and the
Base. While the treadmill is on its side, attach the other
BaseExtension (not shown) inthe same manner.
76 86
eAttach six Base Pads (43) to the Base (86) and the Base
Extensions (76) in the indicated locations. Note: An extra
Base Pad may be included.
With the help of asecond person, carefully raise the
treadmillto the updght position so the Base (86) and the
Base Extensions (76) are resting on the floor.
Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions to lower the treadmill.
2
86
3. Cut the two Shipping Ties from the Handrails (61). 3Shipping
.Remove thefour Handrail Bracket Screws (128) from the
dght side ofthe Frame (83). Position the rightHandrail
Bracket (42) over the four screw holes in the Frame.
Looselythread two of the Screws into the back holesof
the Bracket and intothe Frame as shown.
Repeat this step on the left side of the Frame (83).
5