Sears 911.363209 warranty BEFORE CALLNG FOR SERVmCE, Thermostat Adjustments

Models: 911.363209

1 18
Download 18 pages 51.45 Kb
Page 16
Image 16
BEFORE CALLNG FOR SERVmCE

BEFORE CALLNG FOR SERVmCE

PROBLEM

Foods do not brotl properly

Oven smokes

Oven light or work light does not work

(if equipped)

Continuous-Cleaning oven finish looks soiled

POSSIBLE CAUSE

-Improper rack position

,Oven preheated

Improper utensil used

Improper broiling time

Oven dooropen

Dirty oven

Broiler pan full of grease left in oven

Light switch in off position

-Light bulb burned out

Heavy spilloverswere not wiped up promptly

DON'T CALL FOR SERVIC5

UNTnL YOU CHECK

Check broil pan placement; see Broiling section.

Do not preheat when broiling.

Use broiler pan and grid supplied with range.

Check broiling chart in broiling section.

Close door.

Check for heavy spillover.

Clean pan and grid after each use.

Be sure that sump grease well is to the front of the range when broiling.

Check switch setting°

Check or replace light bulb; see cleaning and care instructions.

See Continuous-Cleaning Oven lnforma tion in cleaning and care sections The continuous-cleaning oven finish wilt not keep your oven spotless; only presentably clean.

THERMOSTAT ADJUSTMENTS

The temperature in your new oven has been set cor- rectly at the factory, so be sure to follow the recipe temperatures and times the first few times you bake in your new oven.

ffyou think the oven should be hotter or cooler, you can adjust it yourself, To decide how much to change the temperature, set the oven temperature 25°F higher or lower than the temperature in your recipe, then bake. The results of this "test" should give you an Idea of how much the temperature should be changed,

3.Use a screwdriver to gooser= the two screws about 1 turn each.

4.Hold the knob handle (A on i_Uustration) while

turning the knob skirt (B on illustration) in the

desired direction• As you turn, you should be able to hear clicks and feel notches or teeth.

Each click or notch is 10 °. You can turn up to 5 clicks or notches in either direction.

5, When you reach the desired adjustment, retighten both screws.

To Adjust Knob:

t. Turn OVEN CONTROL knob to OFF and remove the knob by pulling straight off.

2.Look at the back of the knob. The arrow

pointing to the center of the upper screw

indicates the original factory setting. The knob can be adjusted up to 50°F hotter or 50°F cooler, in 10 ° increments.

MAKES OVEN COOLER

MAKES OVEN HOTTER

(Screw Moved Toward Cooler) (Screw Moved Toward Hotter)

17

NGSER14

Page 16
Image 16
Sears 911.363209 warranty BEFORE CALLNG FOR SERVmCE, Thermostat Adjustments