1 REAR MOUNTING BRACKET
(See Figs. 1 & 2)
Use Hardware - - GROUP "A"
Only one set of hardware in GROUP "B" will be used to mount the rear mounting bracket. To determine which set is correct for your tractor, check to see if there are (2) two upper corner ribs on each side of drawbar, tf your tractor has the upper corner ribs, use the (4) four self tapping bolts If your tractor does not have the corner ribs, use the set of
(4)four bolts and Iocknuts
SELF TAPPING BOLTS
•Assemble the mounting bracket, lanced tabs towards bottom, using the four formed holes on the drawbar
NOTE: Start the self tapping bolts into holes on the drawbar at least two full turns and remove. This will make it
much it much easier to fasten the bolts once the mounting bracket is in place
=Install the four bolts as shown and tighten securely
| UPPER CORNER |
UPPER CORNER | RIBS |
| |
RIBS |
|
SELF
TAPPING
BOLTS | Fig. 1 |
BOLTS AND LOCKNI, JTS
=Assemble the mounting bracket, lanced tabs towards bottom, using the four smaller inside holes on the drawbar,
•Install the four bolts and Iocknuts as shown and tighten securely
BOLTS
LOCKNUTS
LANCED TABS TOWARD BOTTOM
BLY
COVER SEAL (See Fig. 3)
No hardware required
Align mark on seal with mark at cover opening
Work seal into opening so cover sits between flanges of seal
ALIGNMENT
MARKS
COVER SEAL
Fig. 3
SUPPORT POST (See Fig. 4)
Use Hardware - - GROUP "B"
| loaded and locked to the cover. Handle |
|
| cover assembly carefully so as not to |
|
I_ | unlatch the cover from the container | I |
CAUTION: Container support is spring | ||
| support. |
|
•Rotate cover assembly onto its side as shown.
•Assemble support post to container support with the three (3) hex bolts and Iocknuts. Tighten securely_
HEX BOLTS
SUPPORT
POST
/• | / | • |
/
/LOCKNUTS
Fig. 4
Fig. 2
7
