ASSEMBLY
MOUNTING TO TRACTOR (See Fig. 5) Use Hardware - - GROUP "C"
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting assembly to tractor
Raise seat on tractor to allow assembly to be mounted.
With cover closed, lift assembly and place support post inside mounting bracket. Allow assembly to rest on lanced tabs of mounting bracket.
Line up holes in mounting bracket with holes in support post and insert bracket support pin Secure with re- tainer spring
Unlatch and open cover.
Install the three (3) tubing end caps onto container support
Tap each end cap onto container support tubes to seat securely
COVER ASSEMBLY
RETAINER
SPRING
END CAP
SUPPOR"
LANCED TABS
MOUNTING
BRACKET
Fig. 5
CONTAINER ASSEMBLY (See Fig. 6)
No hardware required
•Place bottom half inside of top half, as shown
oPlace one foot inside bottom half and lift top half to meet bottom half
=Press halves tightly together while lifting top to lock into place as shown
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES ON BOTH HALVES MUST OVERLAP TO FORM
SEAL AS SHOWN IN INSET
°Repeat for second container.
CONTAINER
BOTTOM
HALF
PRESSTOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF
TAB
ASSEMBLY CHECK: Squeeze sides of lower half of corr- tainer and check that there is no gap between upper and
lower halve& If a gap appears, unlock tabs to separate container halves and repeat instructions above.
f_
i _ _
,_- f,
Fig. 6
8
