ASSEMBLY
6 CONTAINER MOUNTING (See Fig. 7)
No hardware required
•Install one container to left side first with warning to outside of unit. Install other container to right side.
NOTE: Right container should always overlap left con- tainer at center support.
•Close cover and lock latch handle over center support tube.
COVERLATCH
HANDLE
7 LOWER CHUTE (See Fig. 8 & 9)
Use
•Install two latch hook assemblies, to lower chute using screw, washer, lock washer, and weld nut as shown
°Tighten hardware securely_
•Raise and hold deflector shield in upright position
°Place front of chute over front of mower deck opening and slide into place, as shown
=Hook front latch into tab hole on front of mower deck
• Hook rear latch into tab hole on back of mower deck.
•If your tractor is equipped with gage wheels on the deck, then it will be necessary to use the hole in the R.H. gage wheel mounting bracket•
CONTAINER
CONTAINER
from mower. Raise and hold guard when
attaching lower chute and allow it to rest CAUTION: Do not remove discharge guard I on chute while in operation.
LOCK WASHER
SCREW
HANDLE _ | CENTER |
| SUPPORT |
CONTAINER 3
Fig. 7
WITH OUT | Fig. 8 |
|
GAGE | fJ"_ |
|
WHEELS | ......• | DEFLECTOR |
| © |
|
WITH | Fig. 9a |
GAGE
WHEELSDEFLECTOR
" | " | SHIELD |
9