Sears 917.25147 owner manual To Replace Headlight Bulb, To Adjust Throttle Control Cable

SERVICE ADJUSTMENTS

/

"POSITIVE" (+) "NEGATIVE" _-J

IL.H. PANE_I

BOLT ] _--_,

•3 0

FiG. 26

TO REPLACE HEADLIGHT BULB

Raise hood.

Pul bulb holder out of the hole m the Backside of the grill.

Replace DUIOIn hOlder and push DUIDnolaer secure, back into the ho_e n tile backs:de of the grit

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Ports section of th s manual

TO REPLACE FUSE

Replace w_m 30 amo au_omotwe4ype p_ug-in fuse The fuse holder is located benmna the dash,

TO REMOVE HOOD AND GRILL ASSEMBLY

(See Fig. 27)

Raise hood.

UnsnaD neaa ght w_re connector.

Stand in front of tractor. Grasp hood at sides titttoward engine and lift off of tractor•

To replace reverse aoove oroceeures.

_HOOD

HEADLIGHT

WIRE

CONNECTOR

t'

FIG. 27

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

(See Fig, 28)

The throttle control nas been oreset at the factory and adjustment should not be necessary. Check ad ustment as described De=ow oefore loosening cable. "adjustment s necessary, proceed as follows:

With eng ne nor running, move tnrottie centre lever to fast (,1_,)oosmon.

Check that swivel is against side of quarter circle. If it is not. loosen cable clamp screw and pull cable back unt swive s against auarter circle. Tighten cable _._, ip screw securely.

CLAMPSCREW.f'_--'__

Y,

QUARTER

CIRCLE \

? _ SWtVEL

FIG. 28

TO ADJUST CHOKE CONTROL (See Fig. 29)

The cnoKe centre nas eeen oreset at tne factory aria

aojus_ment should not be necessary. Check adjustment as aescrlDec below before loosening cable. If adjustment IS necessary uroceea as fc ow,s

24