Sears 917.25147 Tools Required for Assembly, To Remove Tractor from Carton, Unpack Carton

LY

Your new tractor has been assembled at the factory with exception of those Darts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all 0arts and hardware you assemble must be tightened securely, Use the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly eas_er. Standard wrench sizes are listed,

(2)	7/16	wrencnes	Utility knife
(1)	1/2	wrencn	Tire Ùressuregauge

When rlgnl or left nana _s memlonea * this manua_ [ means when you are in the operating Position (seated behind me steenng wneeu.

rSTEER,NWHEELINSERT

_._.._LOCKNUT

LARGE FLAT

/"AShZR

fSTEERING

-_-_-_'IWHEEL

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

Remove all accessible 1Dose oars ana OaRScanons from carton (See page 6).

Cut. from top to bottom, along lines on all four corners of carton, and lay panels flat.

Check for any additional _oose pars or cartons and remove.

BEFORE ROLLING TRACTOR OFF SKID

ATTACH STEERING WHEEL (See Fig. 1)

Remove Iocknut ana large fiat washer from steenng shaft.

Position front wheels of the tractor so they are polm_ng straight forward.

Slide the steering sleeve over the steering shaft

Position steenng wheel so cross bars are horizonta deft to right) and slide onto adapter.

Secure steering wheel to steering shaft with Iocknut and large flat washer oreviously removeD. Tighten securely.

SnaD steering wheeI nsen mo center of steering wheel.

Remove orotectlve DlaStiC from tractor hood and gem

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES N SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR S TO ROLL OFF 3KtD.

TO RO LLTRACTOR OFF SKID {See Operation section for location and function of controls)

Press ft Iever 31unger and raise attachment lift lever to its hignest oosmor

Release parKing DraKe by aepress_ng clutch/brake pedal.

Place gearshift lever in neutra fN/ DOShoe. Rc tractor backwards off skid.

l

FIG. 1

CONNECT BATTERY (See Fig. 2)

CAUTION: Do not short battery termi-

nals. Before connecting battery, re-

move metal bracelets, wristwatch

bends, rings, etc.

Positive terminal must be connected

first to prevent sparking from acciden- tal grounding,

Lift hood _o ra_sea DOSe[on

ODen terminal access doors, remove termlna 3rotec-

[ive CaDS and DiscarD,

If this battery sour into service after monm and year indicated on labe labe ecated between terminals

charge battery for minimum of one hour at 6-10 amos.

First connect RED Darter, :aeie to 3ositive (+) battery term qat with hex bolt. flat washer, lock washer and Rex

nut as ShOWn Tighten securely.

Connect BLACK grounding caole to negatwe (-) bat- rer, terminal With rema_nm _ nex Do flat washer loc_ washer ana nex nu_. Tighten securely.

Close terminal access doors

use termlna access doors for:

nsoeciton fol secure connecuons (to tlgnteF narD ware).

7