P 18/ 25
Repair
[3] DISASSEMBLY/ASSEMBLY
[3]-7. Swash bearing section, Piston cylinder section (cont.)
ASSEMBLING
(5)Set Compression spring 14 and Flat washer 14 to the projection of Inner housing as drawn in Fig. 55.
Insert Guide plate and Piston joint into Piston cylinder, and then pass the pole of Swash bearing 10 through Piston joint. (Fig. 56)
(6)Assemble Inner support complete to Inner housing with two M4x25 Hex socket head bolts. (Refer to Fig. 47)
(7)Make sure that the gear teeth of Clutch cam A engage those of Swash bearing 10. (Fig. 57)
(8)Assemble Compression spring 4 and Lock plate to Gear housing. (Fig. 58)
Note: Apply Makita grease RB No. 00 to the end of Compression spring 4 on Lock plate mating side in order to do the next step smoothly.
(9)While holding Lock plate by a finger so as not to drop from the guides of Gear housing, assemble Gear housing to Inner housing. (Figs. 58 and 59)
Fig. 55
Compression spring 14 |
Flat washer 14 |
Projection of |
Inner housing |
Fig. 56
Piston cylinder Guide plate | Inner housing |
It is not necessary to position this hole.
Pole of | Piston joint |
Swash bearing 10 |
|
Note: Apply Makita grease RB No. 00
to the specific portions of Piston joint designated by
Fig. 57
Clutch cam A |
Correct assembling |
Swash bearing 10 |
Fig. 58
Gear housing complete | Compression spring 4 | Lock plate |
Guides of Gear housing
Apply Makita grease RB No. 00 to the portion of Compression spring 4 designated by
.
Fig. 59
