P 25/ 25
Wiring diagram (cont.)
Fig. D-4
DX01, DX02
Connector
Connector viewed from lead wire installation side
Connect Lead wires to Connector with
Flag receptacles as drawn below.
Connector
Black lead wire | Red lead wire |
White lead wire
Lead wires between Connector and Controller have to fixed with these lead wire holders. Do not slack them between the lead wire holders.
Put Lead wires between Connector and Controller into this groove.
Pass Lead wires through the holes of Line filter one by one and place them in the space between Ribs.
(Line filter is not used for some countries.)
Connect Lead wires to DC motor with
Flag receptacles as drawn below.
DC motor
Black
Lead wire 
DC motor
Red | Red mark |
Lead wire |
|
Set DC motor in place so that the red mark faces to the bottom of DX01/ DX02.
Pass Lead wires through the hole of Line filter and place them here.
(Line filter is not used for some countries.)
Put Lead wires between Connector and Controller into this groove.
