;ERVICE AND
I
"POSITIVE" (+) | "NEGATIVE" |
| |
L.H. PANE_ t | / |
FIG.30
TO REPLACE HEADLIGHT BULB
Raise hood.
-Pull bulb holder out of the hole in the backside of the grill.
•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
o Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
Check wiring. See electrical wiring diagram in the Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp
ADJUSTMENTS
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
{See Fig. 32)
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:
,With engine not running, move throttle control lever to fast position.
•Check that swivel is against side of quarter circle. If it is not, loosen cable clamp screw and pult cable back until swivel is against quarter circle. Tighten cable clamp screw securely.
TO ADJUST CHOKE CONTROL (See Fig. 33)
The choke control has been preset at the factory and adjustment should not be necessary. Checkadjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:
*With engine not running, move choke control (located on dash panel) to full choke position.
•Remove air cleaner cover, fitter and cartridge plate to expose carburetor choke (see "AIR FILTER" in the Customer Responsibilities section of this manual).
,Choke should be closed. If it is not, loosen casing clamp screw and move choke cable until choke is completely closed. Tighten casing clamp screw se- curely .....
Reassemble air cleaner.
CLAMP
\
QUARTER
CIRCLE | _ | _\ |
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig, 31)
®Raise hood.
•Unsnap headlight wire connector.
-Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
•To replace, reverse above procedures.
SWIVEL
FIG. 32
CHOKE CLOSED'_
HOOD
\X
HEADLIGHT
WIRE
CONNECTOR
|
| CH KE |
_ | X | LEVER |
CASING'I"
FIG. 31 | 24 | FIG, 33 |
|
