Adjusting the Back Angle | Invacare IMX1 specs

3.8Adjusting the Back Angle

1.Loosen the compression bar hardware A.

2.Rotate the back cushion B around the rigidizer bar C to the desired position.

3.Tighten the compression bar hardware to secure the back cushion in position.

WARNING

DO NOT adjust the center screw in the rigidizer bracket. The center screw D is designed only to hold the compression bar in place during installation. Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.

When tightening the compression bar hardware, alternate back and forth between the two mounting screws to ensure the compression bar is fully secured.

4.Verify that all mounting hardware is properly tightened and the back is held firmly in place on the rigidizer bar.

3 MONO MOUNT

DB

1 & 3

A

C

Part No. 1171914

13

Invacare® Matrx® MX1

Image 13

Invacare IMX1 user manual Adjusting the Back Angle

Contents

Model IMX1 Invacare Matrx MX1 Invacare Matrx MX1 Contents General SymbolsOverview Important Information Invacare Matrx MX1 Outer Cover Limited Warranty North America Installation Information SafetyGeneral Guidelines Intended Use Operating Information Weight Limitation and Model NumbersWARNING Before Installation Installation OverviewMono Mount Included Items Inch 23 cm Tall MX1 Back Cushions Only Installing the Mounting Hardware Band clamp in place Carefully slide the rigidizer bracket onto the band clamp Installing the Tracking Plate on the Back Shell Adjusting the Back Height Installing the Back Shell onto the Mounting Hardware Adjusting the Back Angle Removing the Mono Mount Hardware Fixed Dual Mount Our customer service department Repeat Steps 1-3 for the opposite side Clamp Body Adjustment Installing the Back Installing the Band Clamps Fixed Dual Mount Loosen the compression bar hardware a Adjust the back to the desired height After Installation Adjusting the Back Angle and Back DepthLoosen the screws a on the side of both clamp bodies B Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Options Installing/Adjusting the Lumbar Support Plug InsertsAdhesive Pads Mounting holes B on the back shell C Width Installing the Optional Privacy Flap Cleaning General Cleaning MaintenanceLaundering Inspection Usability Survey USA TRD0283