Fixed Dual Mount | Invacare IMX1 specs

4 FIXED DUAL MOUNT

6.Tighten the compression bar hardware E to hold the locking pins G in place. Do not fully tighten the hardware at this time.

WARNING

DO NOT adjust the center screw in the clamp body. The center screw F is designed only to hold the compression bar in place during installation. Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.

FE G

7.Repeat STEPS 1-6 to install the back onto the remaining band clamp.

It may be necessary to slide the angle adjustable brackets I to allow the clamp body to properly align with the band clamp.

I

Invacare® Matrx® MX1

18

Part No. 1171914

Image 18

Invacare IMX1 user manual Fixed Dual Mount

Contents

Invacare Matrx MX1 Model IMX1 Invacare Matrx MX1 Contents Overview Important Information SymbolsGeneral Invacare Matrx MX1 Limited Warranty North America Outer Cover General Guidelines SafetyInstallation Information Intended Use Weight Limitation and Model NumbersWARNING Operating Information Mono Mount Installation OverviewBefore Installation Included Items Installing the Mounting Hardware Inch 23 cm Tall MX1 Back Cushions Only Carefully slide the rigidizer bracket onto the band clamp Band clamp in place Installing the Tracking Plate on the Back Shell Installing the Back Shell onto the Mounting Hardware Adjusting the Back Height Adjusting the Back Angle Removing the Mono Mount Hardware Our customer service department Fixed Dual Mount Clamp Body Adjustment Repeat Steps 1-3 for the opposite side Installing the Band Clamps Installing the Back Fixed Dual Mount Adjust the back to the desired height Loosen the compression bar hardware a Adjusting the Back Angle and Back Depth After InstallationLoosen the screws a on the side of both clamp bodies B Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Adhesive Pads Installing/Adjusting the Lumbar Support Plug InsertsOptions Mounting holes B on the back shell C Installing the Optional Privacy Flap Width Laundering MaintenanceCleaning General Cleaning Inspection Usability Survey TRD0283 USA