3 MONO MOUNT
3.9Removing the Mono Mount Hardware
1.Open the cushion cover at the bottom of the back cushion (not shown).
C D
4 G
2.Loosen the locking wedge washers A on either side of the rigidizer bracket B.
3.Slide the back cushion C upward until the mounting rail D is disengaged from the rigidizer bracket.
4.Loosen the compression bar hardware E to loosen the band clamp F.
WARNING
DO NOT adjust the center screw in the rigidizer bracket. The center screw C is designed only to hold the compression bar in place during installation. Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.
E |
| H | |
|
| 5 | |
3 |
|
| |
2 |
|
| |
A A | I |
| |
B | F | ||
6 | |||
|
|
5.Use a hex key H to push out the locking pins I from the rigidizer bracket.
6.Separate the rigidizer bracket from the band clamp.
Invacare® Matrx® MX1 | 14 | Part No. 1171914 |
