![](/images/new-backgrounds/1326109/32610933x1.webp)
4.6Installing the Band Clamps
1.Install the two band clamps A onto the back canes B of the wheelchair.
Allow the band clamps to rest on the rigidizer bar C.
B
CA
4.7Installing the Back
1.Align and insert the tabs A on the band clamp B with the slots C in the clamp body D.
2.Ensure the band clamp is fully inserted into the clamp body.
D
A
CB
4 FIXED DUAL MOUNT
3.Loosen the compression bar hardware E, so the clamp body rests flush against the back cane.
WARNING
DO NOT adjust the center screw in the clamp body. The center screw F is designed only to hold the compression bar in place during installation. Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.
4.Insert the two locking pins G into the clamp body to lock the band clamp in position.
The pins should slide into position with little effort. If the pins are difficult to insert, verify that the band clamp is properly centered and fully seated inside the slots H of the clamp body.
5.Ensure both locking pins are fully inserted.
\
H
EG F
Part No. 1171914 | 17 | Invacare® Matrx® MX1 |