6.4Installing the Optional Privacy Flap

Privacy flaps A are available (sold separately) for use with all standard sized MX1 backs. All standard sized backs come with a pre-sewn loop strip across the bottom rear of the cushion cover B for installation of the privacy flap.

Refer to the chart for proper sizing of the privacy flap for the MX1 back.

WIDTH

PRIVACY FLAP

14 in (36 cm)

PFLAP-XS

 

10” x 16” (26 cm x 41 cm)

 

 

15 in (38 cm)

PFLAP-S

16 in (41 cm)

13” x 16” (33 cm x 41 cm)

17 in (43 cm)

PFLAP-M

 

15” x 16” (38 cm x 41 cm)

18 in (46 cm)

1.If installed, remove the seat cushion.

2.Ensure the back is adjusted to the desired height. Refer to Adjusting the Back Height on page 12, Adjusting the Back Height on page 19 or Adjusting the Back Height on page 26.

3.Position the wheelchair in front of you so the back is facing you.

4.Align the hook strip C on the privacy flap with the loop strip sewn on to the bottom rear of the back cover.

5.Pull the opposite end of the privacy flap through the gap between the back and the wheelchair seat D.

6.Secure the loop strip E on the opposite end of the privacy flap to the fastening strip on the wheelchair seat.

The fastening strip pre-installed on the wheelchair seat pan or sling upholstery may be either a hook strip or a loop strip. It may be necessary to install the the double sided hook strip F onto the privacy flap to secure it to the seat.

Detail A

AC

F

6 OPTIONS

Rear View

1-3

DB

4

B A C

Front View

5A

E

D

A

F 6 D

Part No. 1171914

29

Invacare® Matrx® MX1

Page 29
Image 29
Invacare IMX1 user manual Installing the Optional Privacy Flap, Width