Adjusting the Back Height | Invacare IMX1 instruction

5 QUICK RELEASE DUAL MOUNT

7.Adjust the back position in the slots of the adjustable mounting brackets to center the back pan E between the back canes.

8.Tighten the eight hex screws H securing the adjustable mounting brackets D to the back pan.

DD

H H

H H E

5.10 Adjusting the Back Height

WARNING

DO NOT adjust the center screw in the clamp body. The center screw A is designed only to hold the compression bar B in place during installation (Detail B). Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.

1.Loosen the compression bar hardware C on both back canes D.

2.Adjust the back to the desired height (Detail A).

Heightcanes. adjustments must be made equally on both back

3.Tighten the compression bar hardware to secure the clamp bodies E in place.

When re-tightening the compression bar hardware, alternate back and forth between the screws until the compression bar is fully secured.

DETAIL A	DETAIL B
	D
E	C	B
	A

Invacare® Matrx® MX1

26

Part No. 1171914

Image 26

Invacare IMX1 user manual Adjusting the Back Height

Contents

Invacare Matrx MX1 Model IMX1 Invacare Matrx MX1 Contents Overview Important Information SymbolsGeneral Invacare Matrx MX1 Limited Warranty North America Outer Cover General Guidelines SafetyInstallation Information Intended Use Weight Limitation and Model NumbersWARNING Operating Information Mono Mount Installation OverviewBefore Installation Included Items Installing the Mounting Hardware Inch 23 cm Tall MX1 Back Cushions Only Carefully slide the rigidizer bracket onto the band clamp Band clamp in place Installing the Tracking Plate on the Back Shell Installing the Back Shell onto the Mounting Hardware Adjusting the Back Height Adjusting the Back Angle Removing the Mono Mount Hardware Our customer service department Fixed Dual Mount Clamp Body Adjustment Repeat Steps 1-3 for the opposite side Installing the Band Clamps Installing the Back Fixed Dual Mount Adjust the back to the desired height Loosen the compression bar hardware a Loosen the screws a on the side of both clamp bodies B Adjusting the Back Angle and Back DepthAfter Installation Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Adhesive Pads Installing/Adjusting the Lumbar Support Plug InsertsOptions Mounting holes B on the back shell C Installing the Optional Privacy Flap Width Laundering MaintenanceCleaning General Cleaning Inspection Usability Survey TRD0283 USA